Our Company offers fixtures of leading manufacturers from Europe, North America, and China. The list of supply equipment includes shut-off and control valves for heat and water supply in food-processing and petrochemical industries, gas, steam and corrosive liquids. Our engineers will render an advice and provide assistance in integrating the equipment in accordance with clients’ specifications.
As the valves design continuously improving and new models are created using advanced materials, we consistently extend the list of goods with new products meeting the increasing demand of our
Gate Valves are designed to operate fully open or fully closed. Because they operate slowly they prevent fluid hammer, which is detrimental to piping systems. There is very little pressure loss through a gate valve. In the fully closed position, gate valves provide a positive seal under pressure. However, under very low pressure, i.e. 5 psi, light seepage would not be considered abnormal with this kind of valve.
Butterfly valves, like ball valves, operate with a 1/4 turn. They are generally used for handling large flows of gases or liquids, including slurries, but should not be used for throttling for extended periods of time. They are also very compact relative to flanged gate and ball valves.
Butterfly valves, like ball valves, operate with a 1/4 turn. They are generally used for handling large flows of gases or liquids, including slurries, but should not be used for throttling for extended periods of time. They are also very compact relative to flanged gate and ball valves.
With great emphasis on diverse quality parameters, we are offering a wide array of Cast Steel Swing Check Valve. This check valve is developed by using finest quality of material & leading techniques. In addition, the offered check valve is obtainable from us in varied specifications to choose. Our provided check valve is properly tested in terms of quality in order to supply a defect free range.
Flap Valves are put on the end of a flanged pipe to allow the flow of water out of the pipe, but prevent anything from flowing back in, such as sticks, leaves or other debris. Under direct pressure the valve will open, and it will close when the pressure from outfall fluid is relieved.
Steam valves are used to control the flow and pressure level of steam and heated water vapor.
Deluge Systems are intended to deliver large quantities of water over a large area in a relatively short period of time. The Inbal Deluge Valve is FM and VDS approved to 300 psi (21 bar) in sizes 3″, 4″, 6″, and 8″ (80, 100, 150, and 200 mm).
If your requirements are very specific and the market has no standard solutions available, then we develop for you and with you special valves that meet your requirements. From the turning part up to complete valves, from single pieces up to series.
